Ametek Sorensen Asterion DC ASM, Руководство по программированию

Страница: 41 / 162

Asterion DC Multioutput Series
Programming Manual
6-24
M330517-01 Rev C
extensive compatibility testing with the Ethernet interface.
6.4.1
Network Setup Using DHCP Server
For this network setup to work, DHCP mode must be enabled. DHCP mode can be
enabled using the front panel or the serial interface.
6.4.1.1
DHCP
MODE SELECTION USING FRONT PANEL
Navigate to Home
→
Control Interface
→
LAN
→
LAN Configure. Make both DHCP and
Auto-IP as ON to use the DHCP mode of operation, See Figure 6-2
Figure 6-2: LAN Screen (Configure)
NOTE: If DHCP server is not available and Auto-IP is enabled, the unit can assign itself
an IP address in the Auto-IP (dynamic link local addressing) range.
NOTE: In DHCP mode of operation, if Auto-IP is Off and DHCP server is not available,
the IP address will default to 192.168.0.200. See Figure 6-3. This configuration is
not usable for network connection.
Figure 6-3: LAN Screen
6.4.1.2
DHCP
MODE SELECTION USING SERIAL INTERFACE
1. Connect using a computer serial communications program such as Tera Term and
establish communication as described in section 4.2.2.
2. Turn ON DHCP mode using the SCPI command, SYST:NET:DHCPMODE 1.
3. Turn ON AUTO-IP mode using the SCPI command, SYST:NET:AUTOIP 1.
4. Type SYST:NET:APPLY, Press enter to apply the Network settings.
5. After configuring the settings, verify with the queries, SYST:NET:DHCPMODE? and
SYST:NET:AUTOIP?