Ametek Sorensen Asterion DC ASM, Руководство по программированию

Страница: 139 / 162

Asterion DC Multioutput Series
Programming Manual
13-122
M330517-01 Rev C
NOTE: All calibration procedures steps should be performed. Omitting any step or
applicable section may affect the specified performance of the unit.
The CAL1:MOD:LASTCALDATE and CAL1:MOD:NEXTCALDATE commands (Section
10.11) should be issued once calibration procedures have been performed.
Setup for Calibration
This section provides calibration setup for RS232, Ethernet.
STEP DESCRIPTION
1. Disconnect the Unit Under Test (UUT) AC input power. (The UUT is the power
supply that will be calibrated.)
2.
Disconnect all loads from the UUT’s output terminals.
3. Connect the DVM to the UUT output terminals.
4. Perform one of the following:
For RS232 :
Connect the RS232 controller to the rear panel of the UUT using the RS232
null modem cable (see Figure 5-3).
For Ethernet :
Refer to Section 6.4 for Ethernet communication setup. Connect the RJ-45
Ethernet cable to the rear panel of the UUT.
5. Reconnect the AC input power. Turn the unit ON and allow the unit to warm up for
at least 30 minutes.
The UUT is ready for the calibration procedure to be performed.
WARNING
Exercise caution when using and servicing power supplies:
•
High energy levels can be present at the output terminals on all power supplies
in normal operation.
• Potentially lethal voltages exist within the power supply and on the output
terminals of power supplies that are rated at 40V and over.
• Filter capacitors store potentially dangerous energy for some time after power
is removed.
***Note: The Data format <n> each channel number (1, 2 and 3) and each channel
should be calibrated individually.