Ametek Ortec radEAGLET-R 2SG, Руководство пользователя

Страница: 31 / 163

radEAGLET-R User Manual Using the radEAGLET-R
For further processing screenshots, transfer them to your computer with, e.g., Storage
Management in the Web interface (see
7.10 , p. 118 ), or a USB flash drive (see 5.11.2 ,
p. 67 ).
2.3 Starting Up the radEAGLET-R
1. Position the instrument in a low-radiation environment.
If your model is not equipped with an internal source, position the supplied KCl (potta-
sium chloride) box (Fig.
16 , p. 31 ) in front of the detector cap.
Figure 16: Box with potassium chloride (KCl) for stabilization and calibration (Only radEAGLET-R models
without internal source (see E.1 , p. 153 ).)
2. Press and hold down the key (Fig. 8 , p. 26 ).
3. After a couple of seconds the instrument begins to boot when the alarm LEDs (Fig. 1 ,
p. 17 ) begin to flash.
4. You are welcomed by the start-up screen with dots appearing from left to right
(Fig. 17 , p. 32 ).
5. The radEAGLET-R begins an initial stabilization (Fig. 18 , p. 32 , see C.1 , p. 147 for de-
tails).
6. When the stabilization source is identified it is shown (Fig. 19 , p. 33 ).
7. After the stabilization the radEAGLET-R switches to Dose Rate Mode (see 3.1 , p. 35 ).
8. Watch the stabilization status icon on the screen (see 2.1 , p. 23 ).
© innoRIID GmbH • 2020-11-18 Software 3.2.12r • Document 3.3.3b4o 31/163