Ametek Land NIR Series, Руководство по установке

Страница: 16 / 22

Page 10
NIR Thermal Imager Installation Guide
4.3 Ethernet Communications (Gig-E) Data Output
The output from the imager to the PC uses a Gig-E Ethernet link: the cable
standard is Cat 6 or higher. The cable must be screened and the screen
terminated at both ends.
The maximum Gig-E cable length is 80m.
Connect the appropriate Gig-E lead between the RJ45 connector on the rear
of the imager body to that on the PC.
For installations where the imager is mounted within a protection jacket and
end cap, a fully sealed connector is not required.
For all other installations, and IP65 seal is required at the connector on the
rear of the imager.
For details of the cable options available, refer to Section 6 ‘Accessories for
NIR Thermal Imagers’.