INSTALLATION
2
8
DR5200
www.drexelbrook.com
DR5200QS-LM, EDO#6-13-112 - Issue #3
•
Turn the PTFE Wave Horn antenna. Tighten with your fingers.
•
Make sure that the thread is engaged fully.
i
End of the procedure.
2.6 Transport
2.7 Pre-installation requirements
•
Make sure that there is sufficient space on all sides.
•
Protect the signal converter from direct sunlight. If necessary, install the weather protection
accessory.
•
Do not subject the signal converter to heavy vibrations.
Part3B: Attach the PTFE Wave Horn antenna to the process connection
Figure 2-9: Part3B: Attach the PTFE Wave Horn antenna to the process connection
CAUTION!
Do not use tools to attach the antenna to the process connection.
WARNING!
•
Depending on the version, the device will weight approx. 5...30 kg / 11...66 lb. To carry, use
both hands to lift the device carefully by the converter housing. If necessary, lift the device
with a hoist.
•
When handling the device, avoid hard blows, jolts, impact, etc. to prevent damage.
INFORMATION!
Obey the precautions that follow to make sure that the device is correctly installed.
