Ametek DCS-E 1kW Series, Руководство по программированию

Страница: 14 / 32

Isolated Analog Programmer Operation DLM-E Series and DCS-E Series
2.1.1 SW1 Switch Setup
The following sections describe the functions of the various switch positions:
Voltage Programming Range Select (V PROG): SW1-1 , ON (1) position, selects 0-5VDC
programming range for the output voltage. Must also be set to ON (1) position when the Isolated
Analog Programmer is wired for 4-20mA input programming. OFF (0) position, selects 0-
10VDC programming for the output voltage.
Current Programming Range Select (I PROG): SW1-2 , ON (1) position selects 0-5VDC
programming range for the output current. Must also be set to ON (1) position when the Isolated
Analog Programmer is wired for 4-20mA input programming. OFF (0) position, selects 0-10VDC
programming for the output voltage.
OVP Programming Range Select (OVP PROG): SW1-3, ON (1) position selects 0-5VDC
programming of OVP threshold. OFF (0) position, selects 0-10VDC programming for OVP
threshold.
Output Voltage Monitor Range Select (V MON): SW1-4 , ON (1) position selects 0-10VDC
range for readback of output voltage. OFF (0) position selects 0-5VDC readback of output
voltage. 4-20mA readback for output voltage is independent of the position of this switch.
Output Current Monitor Range Select (I MON): SW1-5 , ON (1) position selects 0-10VDC
range for readback of output current. OFF (0) position selects 0-5VDC readback of output
current. 4-20mA readback for output current is independent of the position of this switch.
Remote ON-OFF Level Select (S/D): SW1-6 , ON (1) position selects ACTIVE-HIGH logic level
for disabling the output with the S/D signal of the Isolated Analog Programmer connector. OFF
(0) position selects the ACTIVE-LOW logic level for disabling the output with the S/D signal of
the Isolated Analog connector.
Figure 2–1. Rear Panel View, DLM-E Series 3kW and 4kW Power Supply
Figure 2–2. Rear Panel View, DCS-E Series 1kW Power Supply
2-2 M51A Option