Ametek AMREL SPS-A Series, Руководство по эксплуатации

Страница: 48 / 78

Operation AMREL SPS-A Series
3-6 M550129-01 Rev A
Figure 3-4 and Figure 3-5 descriptions:
1 ETHERNET Connector Connector for remote control via Ethernet.
2 RS232 Connector
Connector for remote control
3 ANALOG CONTROL J1 I/O connector for input programming and analog output
monitoring signals as well as status indication and remote
shutdown signals. See Table 3–1 for individual pin descriptions.
4 SENSE Connector J3 Input connector for load voltage sensing to correct for line
drops in the load cables (see Section 3.6).
4a HV SENSE Connector J3 Input connector for load voltage sensing, 800V models only.
5 LAN LED steady-lit indicates Network connectivity; blinking indicates
“Instrument ID” (See SG Series Programming Manual).
6 RESET Switch Returns configuration parameters to factory default settings.
7 Configuration Switch Four–position DIP switch to configure the unit with a Remote
Digital Programming option.
8 External User
Connector
Provides external auxiliary control signals.
9 Parallel In Connector Allows master/slave configuration of up to five units when
connected to another unit’s Parallel Out connector
See Section 3.10.
10 Parallel Out Connector Allows master/slave configuration of up to five units when
connected to another unit's Parallel In connector.
See Section 3.10.
11 Output Bus Bars Positive (+) and negative (–) outputs.
12 Ground Connection for ground wire.
13 AC Input Connectors Connection for 3-phase AC.