Individual Installalation
-
SUPPORT METHOD
(SUPPLIED BY OTHERS)
Suspension Points
Example of continuous row:
Hanging the Fixture Via Threaded Rods.* (Optional)
1.
Arrange adjustable suspension points to
desired location (Optional: See
below)
2.
Insert
1
4
-20 (M6x1 for International)
bolts and secure with nut.
(supplied by others)
3.
Secure to structure via coupling
(supplied by others)
1.
Hang the Fixture via threaded
rods. (Optional)
2.
Once the fixture is
secure, feed power source
(See Below.)
4.
Spackle in fixture (By Others)
3.
Install Ceiling (By Others)
Fixture MUST be mounted before ceiling is installed.
Example of
IND
(individual) fixture:
(Power can be fed into ANY light module in run)
Feeding Power
Choose
Feed Location
1: Remove Access Plate and
choose Feed Location
2: Remove Wire Nuts (If Applicable)
3: Splice in Feed to Fixture
(according to code)
4: Reattach Access Plate
Wires: Black - C1 Hot
White - C1 Neutral
Green: Ground
(2-Circuit Option)
Red - C2 Hot
White/Red - C2 Neutral
(0-10v Dim Option)
Red - Dim+ (Purple)
White/Red - Dim- (Gray)
Access
Plate
Adjusting Suspension Points
(Optional)
1: Loosen Keps Nuts
(Do NOT remove)
2: Slide Mount to desired
Location
3: Tighten Keps Nuts
Keps
Nuts
BoR
(Beginning of Row)
MoR
(Middle of Row)
EoR
(End of Row)
See submittal layout for
IND & row component
fixture lengths.
Amerlux, LLC. - 178 Bauer Drive, Oakland NJ 07436 - T: 973-882-5010 - F: 973-882-2605
www.amerlux.com
LIGHTING SOLUTIONS
AMERLUX
ADAPT. ABILITY.
R
TM
INSTALLATION INSTRUCTIONS
SHEET #:
WARNING - RISK OF FIRE AND ELECTRICAL SHOCK. FIXTURE MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN
ONLY. FIXTURE IS INTENDED FOR INSTALLATION IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE, LOCAL
AND FEDERAL SPEFCIFICATIONS. DISCONNECT POWER AT ELECTRICAL PANEL BEFORE SERVICING
.
RETAIN THESE INSTRUCTIONS FOR MAINTENANCE REFERENCE.
SPEC. SHEET
REFERENCE:
689-0353 Sheet 1 of 5
MESA
Gyp Board Ceiling
MESA