15
AmeriGlide Vesta Owner’s Manual
10. REMOTE TROUBLESHOOTING
Remote not functioning no lights
1. Check and replace the 9v battery.
Remote not functioning w/lights
1. Confirm the lift is functioning by operating the
onboard control.
2. Remove the stair lift’s cover panel to access the
main circuit board.
3. Press and hold the red button located next to the
17 pin plug on the circuit board (Figure 3).
4. Press and hold the up or down button on the re-
mote control.
5. Release the red button on the circuit board.
The unit at this time should beep and start moving.
If the unit is at one of the end stops, you may find the
lift does not beep when you release the red button on the circuit
board, if that is the case then press the other button on the remote.
If one or both remotes do not work after this procedure, then un-
screw the back cover of the remote (4 screws - 2 are located be-
neath the battery cover) and reverse the dip switch set-
tings (Figure 4), and repeat the steps described above.
FIGURE 4
FIGURE 3
