34
Installing the Remote Controls
There are 2 types of remote control, Infra-Red (IR) & Radio Frequency (RF). Each system comes with
2 remote controls as standard. More can be added if required. IR control is supplied as standard, RF
control is an available option if local IR interference is causing an issue.
The controls have 3 buttons, Up, Down and a red Park button. The park button is only used in con-
junction with the optional intermediate charge point.
To install the remote controls: Infra-Red
The infra-red receivers are mounted in the arm of the chair.
Fit the batteries into the remote controls, then use each of them to call and send the stairlift to and
from the other end of the track and then back again.
The controls are sent pre-programmed to the PCB. However, if there are several stairlifts installed
in close proximity or there are other infra-red/radio sources in the area creating interference, the
Infra-Red signals for each of the stairlifts can be changed so that they do not interfere with each
other.
To change the signal
Remove battery cover and batteries from the control.
Remove the four screws holding the back cover of the control
and carefully remove the PCB from the plastic housing.
Change jumper settings on all controls for this lift to either
1,2 3 or 4.
Carefully, put the PCB back into the plastic housing, replace
back cover, batteries & battery cover.
To program the remote controls to the carriage, cycle through
the menu and adjust
K^fhm^*
to the corresponding jumper
number.
REMOTE CONTROLS