CARE AND MAINTENANCE
Soap residues and mineral deposits are the enemies of your bathtub, particularly in areas where there is hard water. However, cleaning your bathtub at regular intervals
and using proper cleaning agents, you can help your bathtub retain its original sparkling look.
DO NOT USE abrasive cleaners
, as these products will damage the
bathtub surface and metallic finishes. A non-abrasive cleaner is recommended.
Your bathtub does not require the use of special cleaning agents or chemicals.
Normal cleaning is simple and easy.
operating instructions
04
1 Engages the system with jets on HIGH
2 Engages the system with the jets on LOW
3 Engages the system and pulsates the water flow
4
OFF Button Turns the jets OFF
1 2 3 4
5
5 LIGHT Button used to control the optional mood light.
• Press the “Light” button to turn on the mood light
• The light displays 7 vivid colors and 2 sequencing settings.
• To change the light color, press the “Light” button to turn it off and after one second press it again to turn it on.
• The color sequence is as follows: Bright White, Aqua Blue, Soothing Blue, Ocean Blue, Majestic Gold, Shamrock Green, Fiery Red, Chameleon Mode, Party
Mode
• In the event that the light is left turned on, it will automatically turn off after 2 hours continuous operation.
1. Preparation and Cleaning
•
Drain the bathing well of all water.
•
Rotate the jet assembly to remove from jet case.
•
Disassemble the jet assemblies (3 pieces each) and place them in the sink. Use a non-abrasive antibacterial cleaner to
remove any visible residue - rinse with fresh water.
•
Use a non-abrasive antibacterial cleaner to clean the bathing vessel, jet cases, drain stopper and overflow mechanism–
rinse with fresh water.
2. Disinfection
•
Spray the surface area of the jet assemblies and bathing vessel until thoroughly coated with a registered disinfectant.
•
Allow to set for the required disinfection contact period (refer to manufacturer’s specifications) then rinse surfaces with
fresh water.
3. Reassembly
•
Dry the jet assemblies and bathing vessel.
•
Reassemble and replace jets by aligning the 11 o’clock
To preserve the surface finish, annual waxing is recommended. Use a high-grade paste-type automotive wax.
