operating instructions
A i r b at h ®
On/Off Key
1st Press:
The blower starts at 50%
2nd Press:
The blower stops
System Speed
1st Press:
Press and hold to increase the blower speed, release
pressure at the desired speed.
2nd Press:
Press and hold to decrease the blower speed, release
pressure of the desired speed.
Wave Mode
1st Press:
Wave - Speed will vary gradually from maximum to
minimum.
2nd Press:
Pulse - Speed will go directly to minimum and then
straight back to maximum.
3rd Press:
Returns to maximum speed.
Water Level Sensor
If water falls below water level sensor while blower is on, an automatic purge
will initiate in thirty minutes to dry the air channels.
Automatic Purge
Thirty minutes after the water falls below the water level sensor the blower
will start again for a one-minute purge cycle allowing piping
to thoroughly dry.
Always use dedicated outlets for each power supply.**
2
A I R B AT H ® + L I G H T
On/Off Key
1st Press:
The blower starts at 50%.
2nd Press:
The blower stops.
While the blower functions press and hold
3 sec.:
Wave - Speed will vary gradually from maximum to
minimum
6 sec.:
Pulse - Speed will go directly to minimum and then
straight back to maximum.
System Speed
1st Press:
Press and hold to increase the pump speed, release
pressure at the desired speed.
2nd Press:
Press and hold to decrease the pump speed, release
pressure of the desired speed.
Chromotherapy
1st Press:
Auxiliary equipment
ON > White
2nd Press:
Slow rainbow cycle
3rd Press:
Fast rainbow cycle
4th Press:
Turquoise, Blue, Magenta, Red, Orange, Yellow,
Green
Return to slow rainbow cycle
Press and Hold 1 sec.:
Auxiliary equipment OFF
Automatic Purge
*(only available with models equipped with Airbath
®
)
Thirty minutes after the water falls below the water level sensor the blower
will start again for a one-minute purge cycle allowing piping to thoroughly
dry.
Always use dedicated outlets for each power supply.**
**Note: Blower hose for AirBath Systems is shipped loose:
1) Remove red caps from blower and check valve.
2) Attached grey hose to blower and check valve.
3) Tighten clamp around each end.