Operating
Instructions
Safety Instructions
Care and Cleaning
Installation
Instructions
Tr
oubleshooting T
ips
Consumer Support
26
Do not clean the broiler pan or grid in a
self-cleaning oven.
After broiling, remove the broiler pan from
the oven. Remove the grid from the pan.
Carefully pour out the grease from the pan
into a proper container.
Wash and rinse the broiler pan and grid
in hot water with a soap-filled or plastic
scouring pad.
If food has burned on, sprinkle the grid
with detergent while hot and cover with wet
paper towels or a dishcloth. Soaking the
pan will remove burned-on foods.
The broiler pan may be cleaned with a
commercial oven cleaner. If the grid is grey
enamel, it can also be cleaned with an oven
cleaner.
Both the broiler pan and grid can also be
cleaned in the dishwasher.
Do not store a soiled broiler pan and grid anywhere
in the range.
CAUTION:
Do not clean the broiler
pan or grid in a self-cleaning oven.
After broiling, remove the broiler pan
from the oven.
To remove the storage drawer:
Pull the drawer out all the way.
Tilt up the front and remove it.
To replace the storage drawer:
Insert glides at the back of the drawer
beyond the stop on range glides.
Lift the drawer if necessary to insert
easily.
Let the front of the drawer down, then
push in to close.
Clean under the range.
Broiler Pan & Grid
Storage Drawer Removal
Care and cleaning of the range.
It’s a good idea to wipe the control panel
after each use of the oven. Use a damp
cloth to clean or rinse. For cleaning, use
mild soap and water or a 50/50 solution of
vinegar and water. For rinsing, use clean
water. Polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid
cleaners, plastic scouring pads or oven
cleaners on the control panel—they will
damage the finish.
The control knobs may be removed for
easier cleaning.
To remove a knob, pull it straight off the
stem. If a knob is difficult to remove, place
a towel or dishcloth between the knob and
control panel and pull gently. Wash the
knobs in soap and water or a vinegar and
hot water solution.
Before removing the knobs for cleaning,
please note that the knobs are in the
OFF
position. When replacing the knobs, check
the
OFF
position to ensure proper placement.
Do not bend knobs by pulling them up or
down or by hanging a towel or other such
loads. This can damage the shaft.
Pull the knob straight off the stem.
Control Panel and Knobs