M968935 Rev. 1.1
Connect water supply to FAUCET SHANKS
(1)
with 1/2" IPS FLEXIBLE
SUPPLIES
(2)
or 3/8" O.D. BULL-NOSE RISERS
(3)
.
Use adjustable wrench to tighten connections. Do not over tighten.
Be careful not to kink copper supply when bending. Use tubing
cutter to cut to proper length.
MAKE WATER SUPPLY CONNECTIONS
3
FERRULE
COUPLING NUT
1
1
2
3
NOTE: FLEXIBLE SUPPLIES OR BULL-NOSE RISERS MUST BE
PURCHASED SEPARATELY.
ALIGN HANDLES
Pull out INDEX CAP
(1)
and remove
HANDLE SCREW (2), HANDLE
(3)
and ADAPTER
(4)
.
Push ADAPTER
(4)
on VALVE STEM
(5)
.
Find correct position of HANDLE
(3)
by
adjusting male teeth on ADAPTER
(4)
to
female teeth on HANDLE
(3)
.
Replace HANDLE SCREW
(2)
and push
in INDEX CAP
(1)
.
SERVICE
5
To change direction of handle rotation,
proceed as follows:
Turn valve to OFF position.
Pull out INDEX CAP and remove
HANDLE SCREW.
Remove SPRING CLIP.
Lift STOP WASHER, turn 90˚ and replace.
Replace SPRING CLIP.
Replace ADAPTER, HANDLE, SCREW, and INDEX CAP.
AERATOR may accumulate dirt causing distorted and
reduced water flow. Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF
to ON position. Do not force - handles turn only 90
˚
.
SPRING
CLIP
STOP
WASHER
90
˚
1
2
3
4
5
4
TEST INSTALLED FITTING
With HANDLES
(1)
in OFF position, turn on WATER
SUPPLIES
(2)
and check all connections for leaks.
Remove AERATOR
(3)
.
Operate both HANDLES to flush water lines thoroughly.
Replace AERATOR
(3)
.
6
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH WITH
A COARSE SURFACE.
1
2
3
1
