- 3 -
5
• With HANDLE
(1)
in OFF position, turn on WATER
SUPPLIES
(2)
and check all connections for leaks.
• Remove AERATOR
(3)
.
• Operate HANDLE
(1)
to flush water lines thoroughly.
• Replace AERATOR
(3)
.
CHECK DRAIN CONNECTIONS
• Fill lavatory with water. Check that DRAIN STOPPER
(4)
makes a good seal and retains water in SINK.
• Release DRAIN STOPPER
(4)
down and check all drain
connections and “P” trap for leaks. Tighten if necessary.
CARE INSTRUCTIONS:
TEST INSTALLED FITTING
M965900 (8/18)
DO:
SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT:
DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
4
3
“P” TRAP
WASTE
OUTLET
2
1
4
2
3
1
SERVICE
CAUTION
Turn off hot and cold water
supplies before begining.
90˚
90˚
2
3
1
4
5
8
7
5
6
Change Direction of the Handle
• Turn valves to OFF position.
• Turn off water supplies.
• Pull HANDLE
(1)
“UP” firmly to release from PLASTIC INSERT
(6)
.
• Remove SCREW
(3)
and pull off PLASTIC INSERT
(2)
.
• Remove RETAINING O-RING
(4)
.
• Lift and turn STOP WASHER
(5)
90˚. Replace RETAINING
O-RING
(4)
.
• Re-install HANDLE ASSEMBLY.
To Change Cartridge:
• Remove HANDLE
(1)
, ADAPTER
(2)
and SCREW
(3)
via
steps above.
• Remove CARTRIDGE
(7)
by pulling up on it after rotating
CARTRIDGE NUT
(8)
counter clockwise.
Aerator Clean Out
• AERATOR may accumulate dirt causing distorted and reduced
water flow. Remove AERATOR by using the AERATOR KEY
and rinse to clear any debris.
• If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90˚.
