SINGLE CONTROL
PULL-DOWN BAR FAUCET
4285.410
4285.410F15
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.
Installation
Instructions
Certified t o comply with ANSI A112.18.1M
1
INSTALL FAUCET WITH OR WITHOUT DECK ESCUTCHEON
Assemble RUBBER WASHER
(4)
, BRASS WASHER
(5)
, and threaded LOCKNUT
(6)
onto SHANK
(3)
from underside
of sink or mounting surface. Hand tighten LOCKNUT
(6).
Use a screwdriver to tighten SCREWS
(8)
on LOCKNUT
(6)
. Work your way around LOCKNUT
(6)
, tightening
the screws slightly each time until all are snug to ensure even pressure.
Plumbers' Putty or Caulking
Adjustable Wrench
Phillips Screwdriver
RECOMMENDED TOOLS
Regular Screwdriver
Insert HOSES
(2)
through RUBBER WASHER
(4)
, BRASS WASHER
(5)
, and threaded LOCKNUT
(6)
.
Turn off water at
main supply.
CAUTION
PORTSMOUTH™
M 9 6 5 4 5 5 Rev. 1. 2
B
A
SINK OR
MOUNTING
SURFACE
4
5
8
7
6
(A) Installation with ESCUTCHEON (1)
.
Apply a bead of putty to bottom edge of ESCUTCHEON with PUTTY PLATE
(1)
.
Make certain the SEAL
(9)
is properly seated in recess of faucet body. Insert SUPPLY HOSES
(2)
, SPRAY HOSE
(7)
and SHANK
(3)
through hole of ESCUTCHEON with PUTTY PLATE
(1)
and mounting surface.
Follow mounting instructions
below to secure faucet to mounting surface.
(B) Installation less ESCUTCHEON (1).
Discard ESCUTCHEON with PUTTY PLATE
(1)
. Make certain the SEAL
(9)
is properly seated in recess of RING BASE
(10)
. Insert supply HOSES
(2)
, SPRAY HOSE
(7)
and SHANK
(3)
through
mounting hole and seat RING BASE
(10)
onto sink or mounting surface.
Do not use putty
.
RING BASE
7
9
10
3
2
7
1
9
PUTTY
SPOUT BASE
2
3
4
5
8
6
7
