6
CONNECT SUPPLY HOSE TO SYSTEM
Connect water supply hose to connection in back of
toilet for supply line outside of toilet. See Figure 1.
Note: This will ease installation of supply hose
once toilet is installed.
For supply line that is installed behind the toilet,
connect supply hose to Shut-Off Valve first.
Remove Dust Cap by pulling straight up as shown
in Figure 1.
7302429-100 Rev. 1 2/20
- 2 -
CLOSET
FLANGE
CLOSET
BOLTS
A
INSTALL CLOSET BOLTS
Install closet bolts in flange channel, turn 90°, and
slide into place 6" (152 mm) apart and parallel to wall.
POSITION TOILET ON FLANGE
a. Unplug floor waste opening. Ensure supply hose is outside of toilet before installing, for outside toilet supply line. Install toilet on closet flange so
bolts project through mounting holes.
NOTE: To better view closet bolts when lowering toilet over flange, view through Seat Post Openings to align closet bolts through toilet mounting
holes while shinning a flashlight. (reference FIGURE A)
b. Place T-handle through hole opening of seat post about 3 inches and align with bolt. Carefully place plastic flange nut onto T-handle with your free
hand, then lower down over bolt of waste flange and loosely tighten. Repeat for opposite side. (reference FIGURE B)
5
INSTALL WAX SEAL
Invert toilet on floor (cushion to
prevent damage), and install wax
ring evenly around waste flange
(horn), with tapered end of ring
facing toilet.
4
3
WAX RING
WATER SUPPLY CONNECTION TO TOILET
T-HANDLE
FIGURE A
FIGURE B
SEAT POST OPENING
FIGURE 1
DUST
CAP
TOILET WATER
SUPPLY CONNECTION
REGULATOR
Positioned for
outside of toilet
supply connection.
