TEST INSTALLED FAUCET
2
Remove AERATOR.
With handles in OFF position, turn on water supplies and check all connections for leaks.
Operate both handles to flush water lines thoroughly.
Turn handles into OFF position and replace AERATOR.
1
INSTALL FAUCET
Turn off hot and cold water supplies before beginning.
CAUTION
Place faucet in position on sink.
Assemble and tighten LOCKNUTS from underside of SINK.
Connect the HOT water supply to the left SHANK and the
COLD water supply to the right SHANK using appropriate
connectors and sealant (not supplied), and COUPLING NUTS.
LOCKNUT
HOT
COLD
COUPLING NUT
PUTTY
PLATE
BODY
SINK
SHANK
NOT SUPPLIED
Check alignment, if not satisfactory
aligned;
Push out ADAPTER carefully.
Turn ADAPTER either 45˚ or 90˚
so that male square on
ADAPTER catches different
female square in HANDLE BASE.
Assemble and tighten
MOUNTING SCREW.
Push INDEX CAP in top of
HANDLE.
SERVICE
Handle alignment.
3
To change direction of handle rotation,
proceed as follows:
AERATOR may accumulate dirt causing distorted and reduced
water flow. Remove AERATOR and rinse clean.
If spout drips, operate handles several times from OFF to ON
position. Do not force - handles turn only 90
$
.
SPRING
CLIP
STOP
WASHER
90
$
Turn valve to OFF position.
Pull out INDEX CAP and remove
HANDLE SCREW.
Pull off HANDLE BASE and remove
ADAPTER.
Remove SPRING CLIP.
Lift STOP WASHER, turn 90
$
and replace.
Replace SPRING CLIP.
Reinstall HANDLE.
VALVE
STEM
FEMALE SQUARE
IN HANDLE BASE
HANDLE
ADAPTER
SQUARE
4
EverClean™ Finish Care Instructions
American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with
clean water may also be used, if desired. No additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
. 3 & 7
