INSTALLATION AND FRAMING INSTRUCTIONS
Locate studs as required. Ensure roughing-in dimensions are proper, plumb and square. Access to Pump/Motor may be
made through the access opening in the apron panel. It is strongly recommended that an additional opening be provided
for access to the drain components.
NOTE: The apron may be used as the primary access opening.
1. As shown in Fig. 1, mark the position of the underside of the deck by tracing a line onto the studs at the height indicated,
using a level or other suitable straight edge.
2. With the top of the stringer touching the traced line, attach the stringer to the studs.
3. Install drain components to the whirlpool or bath following the manufacturers instructions.
4.
THIS BATH MUST BE SUPPORTED ALONG ITS ENTIRE BOTTOM.
We recommend the use of mortar as bedding
material (sand is not recommended). Apply enough bedding to support the complete bottom of the bath. After the
bedding has been poured, and before it sets, position whirlpool or bath within recess until the rim is leveled against the
leveling stringers (see "Typical Recess Installation") shown below. The rim of the bath
MUST NOT
support weight.
Allow the bedding material to completey harden before applying weight to the rim or bottom of the bath. Any finish
material such as tile or wall board must be self-supporting if it contacts the deck of the bath.
752562-100 Rev. H
2
19
(483mm)
FIG. 1
TYPICAL RECESS INSTALLATION
34 Typ.
(864mm)
19
(483mm)
60-3/16
(1529mm)
3 0
( 7
6 2
m m
)
3 2
( 8
1 3
m m
)
TUB
WIDTH
L E V E L I N G
S T R I N G E R S
SUGGESTED WHIRLPOOL/BATH INSTALLATION METHOD
Leveling Stringer
1 x 3 (25 x 76mm) WOOD
Finished Wall
Waterproof Dry Wall
or Cement Board
Sealant
Tub
Stud
(Wood or Steel)
SECURE THE BATH TO THE STUDS AS SHOWN FOR
WOOD OR STEEL STUD CONSTRUCTION.
