- 2 -
2
M965685 Rev. 1.0 (4/16)
3
CONNECT SPRAY HOSE AND INSTALL WEIGHTS
• Turn off hot and cold water supplies before beginning.
• Connect FLEXIBLE SUPPLY HOSES
(1, 2)
directly to wall
supplies. Connection on fitting supplies are 3/8
"
compression. Connect left supply hose (Red Stripe) to Hot
wall supply. Connect right supply hose (Blue Stripe) to Cold
wall supply. Use adjustable wrench to tighten connections.
Do not over tighten.
*
Faucet supplies are 35
"
long from faucet base.
•
Note: If additional supply length is required, installer
must purchase additional parts separately.
•
Important: If SUPPLY HOSES (1, 2) are too long,
loop as illustrated to avoid kinking.
MAKE WATER SUPPLY CONNECTIONS
1
2
COLD
HOT
7
6
8
2
1
3
4
5
18"
• Push the SPRAY HOSE END
(1)
into the HOSE
CONNECTOR
(2)
and slide down the LOCKING
COLLAR
(3)
until it snaps into place.
• With HAND SPRAY
(4)
seated in SPOUT
(5)
, install
WEIGHT
(6)
at labeled area onto HOSE
(7)
, secure
with SCREW
(8)
.
4
SPRAY OPERATION
• With FAUCET on, press TOGGLE BUTTON
(4)
on SPRAY
(3)
to switch
from stream to spray.
• Press and hold PAUSE BUTTON
(5)
to temporarily stop flow from SPRAY
(3)
. Release PAUSE BUTTON
(5)
to resume flow from SPRAY
(3)
.
STREAM (AERATOR)
SPRAY
5
3
4
• Move HANDLE
(1)
into “off” position.
• Turn on water supplies and check connections for leaks.
• Operate HANDLE
(2)
up and down, left and right to flush
water lines thoroughly.
• Operate HAND SPRAY and check connections for leaks.
CHECK CONNECTIONS FOR LEAKS
CHECK
CONNECTIONS
FOR LEAKS