American Sanders American 12 07044C, Руководство оператора

Страница: 11 / 32

Clarke
®
American Sanders - American 12 Floor Sander Operator's Manual FORM NO. 78150D Page 11
Figure 5
To operate the machine follow this procedure:
1. Install the operator's belt as follows:
a. Position the operator's belt around waist.
b. Cross the straps at the waist. See fi gure 5.
c. Slide the belt loop end over the handle on
the control lever side. Adjust the length as
needed.
d. Wrap the remaining strap around the op-
posite side of the handle and hold it in place
with your hand.
WARNING: Should quick release of the
machine be necessary, serious
operator injury could occur if
the operator has tied the loose
end of the operator's belt strap
to the machine. Always position
the strap so that you can let go
and get away quick in case of
bag
fi re or explosion.
2. Put the On/Off switch into the "ON" position.
DANGER: Serious damage can occur to the
fl oor surface if the machine is not
in motion while the contact wheel
is running on the
fl oor surface. To
prevent damage to the surface,
make sure the machine is always
moving when the contact wheel
is in contact with the
fl oor.
3. Work right to left. For each forward pass, move
the machine 4" over the pass you have just
fi nished. Retrace your reverse path without
overlapping. See fi gure 6.
4. Feather-cut in by easing the contact wheel down
onto the surface with the control lever while the
sander is in motion.
5. When contact wheel is fully engaged with the
surface, gradually adjust your pace for adequate
fi nish removal. Keep sander in motion while the
contact wheel is engaged with the surface or
dwell marks will occur.
6. Move the machine in the direction of the grain
in the wood whenever it is possible. Sand the
surface at a constant pace.
7. Gradually feather-cut out at the termination point
(the end of your pass) by easing the contact
wheel up with the control lever. Stagger the ter-
mination points for a better blend when edging.
8. Empty dust bag whenever it is 1/3 full. Never
leave a dust bag unattended with sanding dust
in it. Sanding dust can spontaneously ignite
and cause a
fi re or explosion. Empty dust into a
metal container located outside of the building .