American Panel HURRICHILL AP120BC1000-3, Руководство пользователя, Страница: 16 / 50

AP120BC1000-3/ AP120BCF1300-3 Manual
15
PROGRAMMING
1. INITIAL PROGRAMMING
NOTE: Initial programming is preset at the factory. Use this section only if changes are
desired. If no changes are to be made, skip to Page 17 ( 2. Programming the cycles ).
a. With the display reading "OFF" , press
("START/STOP") for a few seconds (5 sec.).
b. To change the language, press or then
press .
ENGLISH
Blinks
c. Enter the default password by pressing, in order, the
and buttons.
If the entered password is wrong the display will show,
for 3 seconds:
Then the controller will go back to step c.
TRY AGAIN
Blinks
NOTE: If a wrong password is introduced three times the controller will go into “OFF” state.
During the password typing, button can be used to delete one or more characters.
d. If you do not wish to change the password, press
.
To change the default password, press or
for "YES" then press .
The password will always be a combination of three of the six available cycles:
( "SOFT", "HARD", "SHOCK", "DEF", "UV", "HEAT PROBE ").
Type the new password, then press .
Be sure to remember the new password and keep a record of it in a safe place.
e. To change the year, press or then press
.
2006(year)
Blinks
f. To change the month, press or then
press .
07(month)
Blinks
INITIAL PROGRAMMING
WRONG PASSWORD
TRY AGAIN
INITIAL PROGRAMMING
SET MONTH
07
INITIAL PROGRAMMING
SET YEAR
2006
INITIAL PROGRAMMING
CHANGE PASSWORD?
NO
INITIAL PROGRAMMING
ENTER PASSWORD:
***
INITIAL PROGRAMMING
SELECT LANGUAGE
ENGLISH
OFF