American Lubrication Equipment TIM-390-A1, Руководство пользователя

Страница: 2 / 8

1
SPECIFICATIONS
1. Inlet Air Pressure: 115 PSI Maximum
2. Operation Pressure: 100 PSI Maximum
3. Reservoir Capacity: 23.75 Gallons
ASSEMBLY
Assemble hose, control handle, etc. with Teflon tape and
pipe dope.
CHARGING THE DISPENSER WITH AIR
1. Regulate the air supply hose that you are using to charge the
dispensing unit to 100 PSI maximum.
2. Make sure the air shutoff valve (See Diagram) on the
dispensing unit is in the “Closed” position. (see picture 1)
3. Connect the air supply hose to the air connector on the top
of the tank.
4. Turn the air shutoff valve to the ”Open” position (see picture 2
and Diagram).
5. When the pressure gauge on the dispenser (see picture 3)
reaches 100 PSI, turn the air shutoff valve (See Diagram)
on the dispensing unit to the “Closed” position (see picture 1).
Do not attempt to over-charge the unit with more than 100 PSI.
6. Remove the air supply hose from the air connector on the top
of the tank.
picture 1
picture 2
picture 3
WARNING
Read carefully and understand all INSTRUCTIONS before operating. Failure to follow the
safety rules and other basic safety precautions may result in serious personal injury.
Save these instructions in a safe place and on hand so that they can be read when required.
Keep these instructions to assist in future servicing.
SAFETY PRECAUTIONS
GENERAL SAFETY RULES
WARNING:
Read and understand all instructions.
WARNING:
The warnings, cautions, and instructions discussed in this instruction
manual cannot cover all possible conditions or situations that could occur. It must be
understood by the operator that common sense and caution are factors which cannot be built
into this product, but must be supplied by the operator.
WARNING
• Do not deliver corrosive or flammable liquids.
• Do not expose the tank to heat sources
• Do not weld only use the applicance for its intended purpose.