Page 3 of 4
©2016 American Lighting, Inc. REV1745 www.AmericanLighting.com
11775 E. 45th Ave. Denver, CO 80239 Ph: 1-800-880-1180 Fax: 303-695-7633
FIGURE 4
FIGURE 5
LED RGB Linear Wall Washer
120V
INSTALLATION INSTRUCTIONS
LLW32-RGB
USING DMX-RGB-3 FOR COLOR CONTROL:
If the fixture(s) will be hard to reach after install, and/or you want mixing level sliders; and/or you want to change instantly to preset colors; and/
or you want to use sound activation, then the DMX-RGB-3 should be used as your color controller. Note: DMX-RGB-3 must be located in a dry
location. It includes a 12V DC wall adapter and 7ft power cord which requires a 120V outlet.
Determine which DMX adpator cable will be needed (LW36-XLR3 or LW36-RGB-XLR3-15 or XLR3-CUSTOM, each sold separately) to connect
the color control unit to the first wall washer. Connect the XLR3 cable to the “DMX OUT” port on the back of the unit. See Figure 5.
PRESET COLORS
Red
Red
Chases/
Macro
Fade/
Speed/Strobe
Master/
Dimmer
Green
Blue
Green
Purple
Preset
Orange
Cyan
Magenta
Chases
Yellow
On
POWER IN
DMX OUT
Off
9VDC
500MA
Blue
Strobe
Blackout
Manual RGB
Sound
Sensitivity
White
Macro
Back View
Front View
PRESET COLORS
Red
Red
Chases/
Macro
Fade/
Speed/Strobe
Master/
Dimmer
Green
Blue
Green
Purple
Preset
Orange
Cyan
Magenta
Chases
Yellow
Blue
White
Macro
PRESET COLORS
Red
Red
Chases/
Macro
Fade/
Speed/Strobe
Master/
Dimmer
Green
Blue
Green
Purple
Preset
Orange
Cyan
Magenta
Chases
Yellow
Blue
White
Macro
PRESET COLORS
1. There are nine colors on the DMX-RGB-3 unit preset for quick color changes at the
press of a button.
• Press the “Preset” button at the bottom to activate the function
• Press any of the nine color buttons
• Slide the “Fade/Speed/Strobe” slider up or down to adjust the fade rate from
one preset color to the next (from 0.1 - 60 seconds)
• Slide the “Master/Dimmer” slider up or down to control the brightness
CHASE MODE
2. There are nine chasing effects you can access using the “Chases” function.
• Press the “Chases” button to activate the function
• Slide the “Chases/Macro” slider to move through the chase effects (see below)
• Slide the “Fade/Speed/Strobe” slider up or down to adjust the fade rate from
one preset color to the next (from 0.1 - 60 seconds)
• Slide the “Master/Dimmer” slider up or down to control the brightness
White
Red >Green >Blue
Blue> Yellow
Green> Red
Red> Cyan
Blue> Red
Green> Blue
Green> Red
