Configuring the SDT16-SAT for Service
Part No. 122147-000, Rev. 1
July 22, 2010
The following are general steps for configuring the SDT16-SAT for service. See the installation and configuration guide
(part no. 122146-000) for detailed steps.
2 of 2
Start software and
select SDT16-SAT
Configure SDT16-SAT
for service
Install software and
USB driver; connect
config cable
1
Install the Universal
Configuration Toolkit (UCT)
software and USB driver on
your PC.
2
Connect USB config cable
from the SDT16-SAT to your
laptop PC.
1
Start the UCT software.
2
When Find Devices displays,
verify your SDT16-SAT is
highlighted and click
Select
.
1
When the main window appears,
configure the following settings.
See figures below.
2
Transmit
test packet
to verify
communication with your website
account.
4
5
6
a
If required, change
default setting for
International Gateway.
b
Set up Battery
Information.
c
Set up Controller Clock.
d
Set up Transmission
Schedule and optional
Alarm Delay.
e
Set up Modbus
Communication Settings.
f
Set up channel alarms and
optional debounce.
g
Map Registers.
Main Window
International Gateway
Battery Information
Controller Clock
Transmission Schedule
and Optional Alarm Delay
Channel Alarms and
Optional Debounce
Modbus Communication Settings
Map Registers
Note
:
Map Registers
figure below shows an example
of a typical set up for the Altronic annunciator.
