INDOOR DOME INSTALLATION
SPEEDDOME ULTRA
2-10
Wall Mounting Bracket
This procedure explains how to mount the dome to
a wall. After completing this procedure, go to page
2-17 for dome setup and attachment procedures.
Ensure the wall material, particularly
sheet rock, can support the dome.
Tools Required
Level
Phillips head screwdriver
Drill with 1/4” concrete bit
Ratchet wrench with 5.5mm and 11mm sockets.
Mounting Structure Required
01RHIUWM Wall Mount
a. Bracket, wall mount
1
0500-7664-01
b. Cover, wall mount
1
0500-7663-01
c. Screw, machine, M3x8, PHP
1
5801-1051-120
d. Nut, locking, M3, SS
2
5826-0200-020
e. Anchor bolt, 1/4x2.25 w/Hdwr
4*
2880-0011
f.
Anchor, plastic
4*
2880-0073-01
g. Washer, flat, LOD, M4
4*
5842-0300-020
h. Screw, STAP, AB, 4.2x32, PHP
4*
5810-4091-120
* The fourth piece is required for the corner mount, if used.
Procedure
Referring to Figure 2-9:
1. Place bracket [a] on wall, level, and mark
mounting hole locations.
2. Anchor by performing step 2a, 2b, or 2c.
a.
To sheet rock:
Use anchor [f], washer [g], and
screw [h].
b.
To wood:
Use washer [g], and screw [h].
c.
To concrete:
Use anchor hardware [e].
3. Attach the base or top hat housing by per-
forming step 3a or 3b.
a.
Direct base attachment.
Attach the dome’s base
to the bracket using two M3 locking nuts [d]. Feed
cables as shown.
b.
Top hat housing attachment.
See “Top Hat Hous-
ing”, page 3-5.
4. Place cover [b] over the bracket and secure
using one M3x8 screw [c].
5. Go to “Dome Setup and Attachment”, page
2-17.
Figure 2-9. Wall mounting bracket
c
b
e
Base
Use center hole for top
hat housing attachment.
Use side hole for direct
base attachment.
a
d
h
f
g
