American Dynamics RAS918LS, Инструкция по установке и обслуживанию, Страница: 12 / 37

SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME 8200-0184-14, REV. A
INSTALLATION AND SERVICE GUIDE
12 of 37
Use the following addresses for the protocols
shown:
PROTOCOL SW3 SW2 SW1
AD Manchester ,
Range: 001—064
0 x x
PELCO "P," 4800 baud RS-
422, Range: 001—099
0 x x
Sensormatic , 4800 baud
RS-422, Range: 001—063,
065—099
0 x x
Sensormatic, RS-422
Address 64 is used for global
broadcasts
0 6 4
SensorNet ,
Range: 001—099
0 x x
VICON , 4800 baud RS-422,
Range: 001—099
0 x x
1 x x SensorNet ,
Range: 100—254
2 x x
Address 255 is used for
global broadcasts 2 5 5
Dept. of Transportation
(NTCIP)
, 4800 baud RS-422,
Range: 301—399
3 x x
Dept. of Transportation
(NTCIP)
, 9600 baud RS-422,
Range: 401—499
4 x x
Dept. of Transportation
(NTCIP)
, 19.2K baud RS-422,
Range: 501—599
5 x x
PELCO "P," 2400 baud RS-
422, Range: 601—699
6 x x
PELCO "P," 9600 baud RS-
422, Range: 701—799
7 x x
Reset HITACHI VK-xxxx(E)R
camera block from 38.4K to
4800 baud (SpeedDome Ultra
VII WITH EIS 0100+ feature
only).
8 3 0
PANASONIC UTC 8 9 0
Tyco UTC 8 9 1
PELCO UTC (Origins,
Standard, & Extended)
8 9 3
RS-422, LED diagnostic
mode for dome wiring
installations without the I/O
Board 9 0 0
Manufacturing Use ,
Range: 901—999
9 x x
2. Attach the safety lanyard to the cap on the
housing and eyeball assembly (Figure 12). Use
the M3x6 screw supplied with the lanyard.
Figure 12. Attaching safety lanyard
3. WITH POWER OFF, connect the video cable
(Figure 13).
a. Connect BNC of video micro coax cable
6003-0170-01 to BNC of video cable.
b. Feed cable through access hole in base.
c. Press the micro coax connector into the
mating receptacle in the top of the housing
and eyeball assembly. A firm snap indicates
a tight connection.
Only use this
location to secure
lanyard.