American Dynamics Multivision Quest TMV910Q, Руководство пользователя

Страница: 45 / 80

Triplex Digital Video Multiplexer
Advanced Setup Using On-Screen Menus 37
Configuration Table 2
Used to configure
Alarm In
&
Motion Detect
operation for Day/Night time frames.
The default values for the parameters in Configuration Table 2 are as follows:
A description of each parameter in Configuration Table 2 is presented in the table
below.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Alm In Type O O O O O O O O O O O O O O O O
Motion Algr D1 D1 D1 D1 D1 D1 D1 D1 D1 D1 D1 D1 D1 D1 D1 D1
Day: Alm In
9 9 9 9 9 9 9 9 9 9 9 9 9 9 9 9
Day: Motion
9 9 9 9 9 9 9 9 9 9 9 9 9 9 9 9
Night: Alm In
9 9 9 9 9 9 9 9 9 9 9 9 9 9 9 9
Night: Motion
9 9 9 9 9 9 9 9 9 9 9 9 9 9 9 9
PARAMETER DESCRIPTION
Alarm in Type Defines the signal type of the external alarm sensor as
Normally-Open (O) or Normally-Closed (C).
Motion Algr Select the motion detect algorithm for each camera:
D1=Normal (suitable to detect a small change in a large area
or for INDOOR usage), D2=Special (suitable to detect rapid
changes in a small area or for OUTDOOR usage); see also
Motion Detection on page 41 for motion detection set up.
Day Alm In Used to enable or disable each Alarm In pin during the Day
Frame, (
3
= enabled,
y
= disabled).
Day Motion Used to enable or disable motion detection for each camera
during the Day Frame, (
3
= enabled,
y
=disabled).
Night Alm In
Used to enable or disable each Alarm In pin during the
Night Frame, (
3
= enabled,
y
= disabled).
Night Motion Used to enable or disable motion detection for each camera
during the Night Frame, (
3
= enabled,
y
= disabled).