4
Intellex
®
Digital Video Management System
Sensormatic Video Systems Division
6795 Flanders Drive
San Diego, California 92121-2903
TEL:
858-642-2400
800-854-2057
FAX:
858-642-2440
CustomerCare:
800-507-6268
The information in this document was current when published. The manufacturer reserves the right to
revise and improve its products. All specifications are therefore subject to change without notice.
Under copyright laws, the contents of this document may not be copied, photocopied, reproduced, trans-
lated or reduced to any electronic medium or machine-readable form, in whole or in part, without prior
written consent of Sensormatic Video Systems Division.
© Copyright 1999-2000 Sensormatic Electronics Corporation
Intellex
®
and Touch Tracker
®
are registered trademarks and Network Client
™
is a trademark of Sensormatic
Electronics Corporation.
Video Signal Termination
Setting the video signal termination to 75 ohms electrically
terminates the signal (i.e., provides the proper load), but the
signal is still available on its associated Camera Out connector.
When video is looped from one unit to another through Camera
Out connectors, video signal termination should be set to
HiZ
in the Intellex software on all but the last unit and should be
terminated to
75 ohms
ONLY on the last unit in the chain.
Part Number 8000-2232-01 REV A
