Controlling Cameras and Their Outputs
3-11
As the Sequence is running, the LCD indicates which camera's video is
displayed, which event in the Sequence is currently active, and how many
seconds remain in that event's duration time.
The Sequence will repeat itself indefinitely until you press either the
Seq
button or the
Clear
button on the Main T
OUCH
T
RACKER
.
Controlling Dome Outputs
The programmable domes at your facility can have outputs connected to
them. Outputs are devices such as lights, audible alarms, or door locks, that
can be controlled via the T
OUCH
T
RACKER
when they are connected to a
dome. Each dome can have up to four outputs connected to it. You can
control the state of any output that is connected to the currently selected
dome.
Because up to 64 outputs can be configured at a single facility, it might be
useful to post the List of Inputs and Outputs, which is included in Appendix
A, next to the T
OUCH
T
RACKER
. This chart lists which output devices are
connected to which domes at your facility. Posting such a list next to the
T
OUCH
T
RACKER
enables operators to easily determine what outputs are
available, and which buttons correspond to those outputs.
The following procedure describes how to turn a dome output on and off.
The on and off states for each dome output are also included on the List of
Inputs and Outputs. You must know the number of the dome (1 – 16) that the
output is connected to, and the output number (1– 4) before you begin this
procedure.
1.
Refer to your List of Inputs and Outputs to determine which output you
want to turn on or off.
2.
Use the number buttons to enter the number of the camera whose output
state you want to toggle, for example, camera 13. Then press
Camera
.
3.
Use the number buttons to enter the number of the output you want to
control. Then press the
Output On
button (if you want to turn the
output on), or press the
Output Off
button (if you want to turn the
