American Dryer Corp. AD-4545, Руководство по обслуживанию

Страница: 9 / 10

450331 - 1 www.amdry.com 9
1. Remove back guard.
2. Remove drive belt.
3. Disconnect wiring harness from motor.
IMPORTANT: If top pocket is being replaced, ductwork
on the side of the motor mount must be removed.
4. Remove nuts and washers holding the motor mount to
the rear of the dryer and pull motor mount away.
5. Remove the two left-hand nuts on the motor shaft
retaining the impellor. Work the impellor free from the
motor shaft by means of a puller to prevent damage to
the motor shaft.
6. Remove the bolts holding the motor and install on new
motor.
7. Remove pulley from old motor and install on new motor.
Motor/Impellor Removal:
9. Replace back guard.
10. Reconnect power to dryer.
Tumbler Alignment (Lateral)
1. Discontinue power to the dryer.
2. Remove back guard.
3. Loosen the two hex head bolts, (one turn is enough),
that holds the pillow block bearing to the bearing box.
4. Back off the two jam nuts on the side adjustment bolts.
Now rotate the tumbler from the front of the dryer,
checking the space between the tumbler and the front
panel. This should be equal on the left-hand and right-
hand side.
5. Lateral adjustment (viewing from the rear)
a. Loosening (by turning counterclockwise) the left-hand
adjustment bolt and tightening (by turning clockwise)
the right-hand adjustment bolt will shift the basket to
the right.
b. Loosening (by turning counterclockwise) the right-
hand adjustment bolt and tightening (by turning
clockwise) the left-hand adjustment bolt will shift the
basket to the left.
6. Tighten and secure both adjustment bolts and jam nuts.
7. Tighten the bearing box bolts.