Operating Modes:
• Sound-Active mode - In this mode the unit will react to sound.
• Auto Mode - In the mode the unit will
• DMX control mode - This function will allow you to control each
individual fixtures traits with a standard DMX 512
controller such as
as the Elation
®
Show Designer™.
Sound Active Mode:
1. Plug the fixture in and put dipswitch #1 in the “ON” postion.
2. The fixture will now change via sound.
3. The optional
UC3 Controller
(not included)
may be used to
control different functions including blackout.
Auto Mode:
1. Put dipswitches 1 & 2 in the “On” position to run Auto Mode.
2. Dipswitch #3 will reverse rotation, while dipswitches 4, 5, and 6
will control rotation speed.
3. The optional
UC3 Controller
(not included)
may be used to
control different functions including blackout.
Master-Slave Operation (Sound Active):
This mode will
allow you to link up to 16 units together and operate without a control-
ler. In Master-Slave mode, the units will react to sound. In Master-Slave
operation one unit will act as the controlling unit and the others will
react to the controlling units programs. Any unit can act as a Master
or as a Slave.
1. Using standard XLR microphone cables, daisy chain your units
together via the XLR connector on the rear of the units. Remem-
ber the Male XLR connector is the input and the Female XLR
connector is the output. For longer cable runs we suggest a
terminator at the last fixture.
2. Choose a unit to function as the Master and set dipswitch #1 to
the “On” position.. This unit must be the first unit in line. Then
sim-
ply daisy chain the units together using XLR cables.
3.
For the Slave units, put any dipswitch in the “On” position, except
the #1 dipswitch.
The #1 dispswitch must stay in the “Off” position on all Slave
units.
Note: When running fixtures in Master/Slave configura-
tion dipswitch 10 in the “On” position will make the fixture do
Tri Pearl LED™ Operating Instructions
©
American DJ Supply
®
- www.americandj.com - Tri Pearl LED™ User Manual Page 8
©
American DJ Supply
®
- www.americandj.com - Tri Pearl LED™ User Manual Page 7
the opposite to the other fixture. Example: Four fixtures linked
together. On fixtures 1 and 3 put dipswitch 10 in the “On” posi-
tion. Now fixtures 1 & 3 will run the same and fixtures 2 & 4 will
run opposite. This makes a great light show.
4. The optional
UC3 Controller
(not included)
may be used to
control different functions including blackout.
DMX Mode:
Operating through a DMX controller give the user the freedom to cre-
ate their own programs tailored to their own individual needs.
1. This function will allow you to control each individual fixture’s
traits with a standard DMX 512 controller such as the
Elation
®
Show Designer™ or the Elation
®
DMX Operator.™
2. The Tri Pearl LED™ uses three DMX channels. See the bottom of
this page for the DMX traits.
3. To run your fixture in DMX mode, plug in the fixture via the XLR
connections to any standard DMX controller. Set your desired
DMX address following the set-up specifications that come with
your DMX controller.
Tri Pearl LED™ Operating Instructions
First unplug the power. The fuse holder is located next to the power
cord. Using a flat-head screw driver unscrew the fuse holder. Remove
the bad fuse and replace with a new one.
Tri Pearl LED™ Fuse Replacement
