ADJ Products, LLC - www.adj.com - Sweeper Beam Quad LED User Manual Page 11
ADJ Products, LLC - www.adj.com - Sweeper Beam Quad LED User Manual Page 12
SENS -
Sound sensitivity control.
1. Press the MENU button until “
SENS
” is displayed, press ENTER.
2. The display will show a number between 0-100. Press the UP or
DOWN buttons to adjust the sound sensitivity. 0 being the least sen-
sitive and 100 the most sensitive.
3. Press the ENTER button to confirm.
DNST
- This mode can be used as a precaution mode, that
in case the DMX signal is lost, the operating mode chosen in
the setup is the running mode the fixture will go into when
the DMX signal is lost. You can also set this as the operat-
ing mode you would like the unit to return to when power is
applied.
1. Press the MENU button until “
DNST
” is displayed, press
ENTER.
2. Either “
MAST
”, “
BLND
”, or “
LAST
” will be displayed. Choose
an operating mode you would like the unit to start up in when
power is applied or the DMX signal is lost.
•
MAST
(Master Slave) - If the DMX signal is lost or power is
applied, the unit will automatically go into Master Slave mode.
•
BLND
(Blackout) - If the DMX signal is lost or power is applied,
the unit will automatically go into stand by mode.
•
LAST
(Last State) - If the DMX signal is lost the fixture will stay
in the last DMX set up. If power is applied and this mode is set,
the unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up
LED -
With this function you can have the LED display
turn off after 10 seconds.
1. Press the MENU button until “
LED
” is displayed, press
Sweeper Beam Quad LED
System Menu
SET -
This will set the Sweeper to a preset angle.
1. Press the either the MENU button until “
SET
” is displayed,
press ENTER. Either “
150
”, “
120
”, or “
90
” will be displayed,
these are the preset angles.
2. Press the UP or DOWN buttons to choose your desired angle
and press ENTER to confim and exit.
SHND: SH
0
-
SH16
-
Show modes 0-16 (Factory
programs). Show mode can run with or without sound active
mode.
1. Press the MENU button until “
SHND
” is displayed, press
ENTER.
2. “
Sh
X
” will now be displayed, “X” representing a number
between 0-16. Programs 1-16 are factory programs, while “
Sh
0
” is random mode. Press the UP or DOWN buttons to find your
desired show.
3. When you have found your desired show press ENTER, then
press and hold the MENU button for at least 3 seconds to acti-
vate.
SOUN -
Sound Active mode.
1. Press the MENU button until “
SOUN
” is displayed, press
ENTER.
2. The display will show either “
ON”
or
“OFF
”. Press the UP or
DOWN buttons to select “
ON
” to activate sound active mode,
or “
OFF
” to deactivate sound active mode.
3. Press ENTER, and then press and hold the MENU button for
at least 3 seconds to activate.
Sweeper Beam Quad LED
System Menu
