American DJ® www.americandj.com - RGBW4C Page 11
RGBW4C Chase Chart
RGBW4C Operation
Note: When the power is switched Off and then back On, the
controller will return to the last operating mode.
Sound Active Mode:
1. Press the SOUND ACTIVE button and the corresponding LED
above the button will light.
2. Use the SOUND SENSITIVITY knob located at the rear to adjust
the sound sensitivity level.
3. Use the faders (10, 11, & 12) to adjust the LED intensity & fade
time. The RED/SPEED fader (13) cannot be used in this mode.
Chase Mode:
1. Press the CHASE button and the corresponding LED above the
button will light.
2. Press 1 of the 9 COLOR buttons (14) located in the Color/Chases
region to activate a chase. Please see the chase chart on page 12.
3. Once your desired chase program has been selected, use the
faders (10, 11, 12, & 13) to adjust the LED intensity, fade time, and
chase speed.
Auto Mode:
1. Press the AUTO button and the corresponding LED above the but-
ton will light.
2. Use the faders (10, 11, 12, & 13) to adjust the LED intensity, fade
time, and chase speed.
Color Macros Mode:
1. Press the COLOR MACROS button and the corresponding LED
above the button will light.
2. Use the faders (10, 11, 12, & 13) to adjust the preferable static
color, LED intensity, and fade time.
RGB Fade Mode:
1. Press the RGB FADE button and the corresponding LED above the
button will light.
2. Use the faders (10, 11, 12, & 13) to adjust the LED intensity, fade
time, and chase speed.
Manual RGBW Color Mode:
1. Press the MANUAL RGBW button and the corresponding LED
above the button will light.
BUTTONS IN COLORS/CHASES REGION CHASE MODE DESCRIPTION
RED button
Red/Green chase
ORANGE button
Green/Blue chase
YELLOW button
Red/Blue chase
GREEN button
Red/Cyan chase
CYAN button
Green/Purple chase
BLUE button
Yellow/Blue chase
PURPLE button
Red/Green/Blue/Yellow/Purple/Cyan/White
chase
MAGENTA button
Red/Green/Blue/Red/Blue/
Yellow
/Cyan/
Yellow chase
WHITE button
Yellow/Purple chase
American DJ® www.americandj.com - RGBW4C Page 12
RGBW4C Operation
2. Press any of the 9 color buttons or use the RGBW faders to make
your own desired color.
3. Use the faders (10, 11, 12, & 13) to adjust the LED intensities.
Preset Mode: Using these buttons you are able to save and recall a
chase, color, or program.
1. To save a chase, color, or program, press 1 of the 3 PRESET but-
ton for at least 3 seconds. When all of the LEDs flash 3 times, this
informs you that the save was successful.
2. To recall the saved chase, color, or program, press the correspond-
ing PRESET button.
