American DJ Q-MX1, Инструкция пользователя

Страница: 9 / 14

INPUTS/OUTPUTS:
The Q-MX1 allows you two types of output connectors Balanced XLR (23) and Unbalanced RCA (30, 31,
and 32). Use these connection to connect the output signal from a mixer, cross-over or EQ to your Q-MX1
mixer. A balanced connection is recommended for cable runs longer that 10ft. When constructing your own XLR
cables follow the pin confi guration describe below for proper connections. For cable runs shorter than 10Ft.
you may choose the RCA unbalanced output option. The unbalanced output option may be more convenient
for most users due to the abundant supply of prefabricated cables on the market.
All the input options on the mixer are unbalanced RCA's. For best results do not use cable run longer than 10ft
for any incoming audio source, longer cable runs will result in inferior sound quality.
©
American DJ Supply
®
- www.americandj.com - Q-MX1 User Instructions page 9
SET-UP INSTRUCTIONS
Figure 3
2 Hot (+ data)
3 Negative (- data) 1 Ground/Return/ 0v)
1
2
3
Male XLR Pin Confi guration:
Connections (Refer to diagrams on page 7, 11, & 12
)
• Before you connect the unit's main power supply, be sure local voltage matches that of the required mixer
voltage. Remember the mixer can be selected to operate with either 115v or 230v. Operational can be
changed by the Voltage Selector (22) on the rear of the unit.
• Be sure the power switch is in the OFF position before making any type of connections to the mixer. Also
be sure the power on all units being connected to the mixer have been switched off.
• Before switch the power on the mixer be sure Main Volume (16) is turned down and the power switch to
all your amplifier are in the "OFF" position.
• Connect the mixers Master Output Jacks (23 or 30) to your audio system. Make sure that the channels
are set properly. When using the Balanced Output Jacks (23) be sure your cable follow the above Pin
Configuration (Figure 3).
• For recording, connect your tape recorder or cassette deck to the REC OUT Jacks (32). The Record Out
level will not be influenced by the Master Volume Control (16). The Record Out (REC OUT) level is
dictated by the Channel Fader Level (4).
• Connect a microphone to any of the three available Mic Input Jacks (10, 26, & 27).
• You can connect up to 3 turntables using the Phono 1 (39), Phono 2 (36), or Phono 3 (34) RCA jacks on
the rear panel. The mixer will only accept turntable level signal if Line Level Switches (37) are in the
"PHONO" position.
• Connect your tape recorder, tuner, sound effects, CD player, and cassette decks etc. to the RCA Line
Level Input Jacks (33, 35, and 38) on the rear panel. CD players, cassette decks and other line level
instruments may also be connected to the "Phono RCA Jacks (34, 36, and 39) as long as the Line Level
Switches (37) are in the "AUX" position.