©
American DJ Supply
®
- www.americandj.com - Mighty Scan™ Instruction Manual Page 13
Halogen Lamp Warning:
This fixture is fitted with a halogen lamp which is
highly susceptible to damage if improperly han-
dled. Never touch the lamp with your bare fingers
as the oil from your hands will shorten lamp life.
Also, never move the fixture until the lamp has
had ample time to cool. Remember, lamps are not
covered under warranty conditions.
Conductor
5-Pin XLR Male (In)
3-Pin XLR Female (Out)
Pin 1
Do Not Use
Do Not Use
Pin 3
Pin 2
Pin 1
Pin 3
Pin 2
Not Used
Not Used
Data True (+ signal)
Data Compliment (- signal)
Ground/Shield
3-Pin XLR to 5-Pin XLR Conversion
Mighty Scan™
Lens Focusing
Mighty Scan™
Halogen Lamp Warning
1. Hang the fixture in your final desired position.
2. If no controller is being used,
A. Set dip switch ten (10) to the on position.
B. Turn the sensitivity to minimum position.
C. Plug the fixture in. The unit’s shutter will open and the
mirror will reset to the center.
3. If a controller is being used,
A. Plug the fixture in.
B. Use your controller to set the fixture’s mirror in a center
home position.
C. Open the shutter and select a gobo.
4. Adjust lens by turning it in a clockwise and counter-clockwise
direction until the projected pattern is in a sharp focus.
Mighty Scan™
Lens Focusing
©
American DJ Supply
®
- www.americandj.com - Mighty Scan™ Instruction Manual Page 14
Unit Top Cover
Mighty Scan™
Fuse & Lamp Replacement
Caution:
Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
®
techni-
cian. Replacing with anything other than the specified part can dam-
age the unit and will void the manufactures warranty.
Warning:
If, after replacing the lamp or fuse either one continues
to blow, STOP using the unit. Contact customer support for further
instructions, you may have to return the unit for servicing. Continuing
to use the unit may cause serious damage.
Fuse Replacement:
Disconnect the unit’s main power supply.
Insert a standard flat head screw driver in to the fuse holder housing.
Remove the fuse holder to expose the fuse. Remove the old fuse and
discard it. Replace the fuse with the same type. Insert the fuse holder
back into it’s housing and turn it in clockwise direction to lock the
holder in place.
Lamp Replacement:
Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power
and allow the unit ample time to cool before attempting to replace the
lamp. Lamp replacement has been made simple by incorporating the
use of a flip-up top cover that is retained by a single thumb screw.
1. Be sure to follow the proper handling procedures that deal
with halogen lamps.
Never touch the new lamp with your bare
fingers.
2. Remove the single thumb screw located on top of the unit. This
screw holds the flip-up lamp socket assembly cover in place.
3. Flip-up the cover. The cover is on hinges and will not fall off.
4. Carefully remove the old lamp and discard it in the trash.
5. Replace the lamp with an exact match and reassemble.
Flip-Up Lamp Cover
Thumb Screw Retaining Hole
Lamp/Socket Assembly