follow the dip switch settings on page 8. If starting at a higher
DMX channel follow the standard DMX Binary Code for a two (2)
channel unit.
6. For help running in DMX operation consult the manual that comes
with your DMX controller.
7. For longer cable runs we suggest using a terminator on the last
fixture.
The 1/4” phone plug on the unit is for the optional Marvel/C. Do
not attempt to connect an audio signal this jack, this will damage
the PC board and void your manufactures warranty!
Lamp Replacement:
Caution! To avoid the risk of electrical shock
or injury never attempt to open up the unit while it is in use. Always
disconnect the main power before attempting to replace the lamp or
fuse. Remember to always replace with the exact same type lamp and
fuse unless otherwise instructed to do so by an authorized American
DJ service technician.
1. Be sure to follow the proper procedures when handling halogen
bulbs.
2. Loosen the screw on trap door located on top of the unit.
3. Remove the trap door.
4. Remove and replace the bulb.
5. Reassemble.
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning the
internal and external optical lenses must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment
in which the fixture operates (i.e. smoke, fog residue, dust, dew).
1. Use normal glass cleaner and a soft cloth to wipe down the
outside casing.
2. Use a brush to wipe down the fan grill and remove as much
built up as possible.
3. Clean the external optics with glass cleaner and a soft cloth
every 20 days.
4. Clean the internal optics with glass cleaner and a soft cloth
every 30-60 days.
5. Always be sure to dry all parts completely before plugging the
unit in.
©
American DJ Supply
®
www.americandj.com Marvel Instruction Manual Page 6
Stand Alone:
1. This function allows a single unit to run to the beat of the music.
Only use this function when running a single unit or when running
more than one unit as an individual.
2. To activate this mode set dip switches #1 and #10, on the front of
unit to the ON position (
See master fixture on the DIP SWITCH
chart on page 4
).
3. Plug the unit in, the unit will react to sound via its own internal
microphone.
4. The optional
Marvel/C controller
may be used with this function
for blackout.
Master / Slave Operation:
1. This function allows you to set up several units to operate without
a controller.
2. The units will be sound activated and will run built in programs via
an internal microphone.
3. To activate this function set one unit, the master unit, dip switches
as followed: Set dip switches #1 and #10 to the on position (
see
the chart on page 7
).
4. For additional units (slaves), up to 16 units total, follow the chart
on page 7.
5. Connect the units together via XLR cables remembering that the
Male XLR socket is IN
and the
Female XLR socket is OUT
.
6. The optional
Marvel/C controller
may be used for black out.
7. For longer cable runs we suggest a terminator at the last fixture.
Universal DMX Control:
1. This function allows you to use a standard DMX controller such as
the American DJ Show Designer™.
2. The use of a DMX controller will allow you to customize the use
of fixtures allowing you independent control of the colors, mirror,
and the ability to black out.
3. This will allow you to create your own programs.
4. The Marvel™
is a DMX two channel fixture; channel one
controls the color and shutter, channel two controls the mirror
movement.
5. When using a DMX controller and setting up for DMX operation
©American DJ Supply® www.americandj.com Marvel Instruction Manual Page 5
Marvel™ Operation
Marvel™ Operation
