ADJ Products, LLC - www.adj.com - Inno Pocket Spot Instruction Manual Page 18
ADJ Products, LLC - www.adj.com - Inno Pocket Spot Instruction Manual Page 19
The
UC-IR
infrared remote gives you control of various functions
(See below)
. To control the fixture you must aim the remote at the
front of the fixture and be no more then 30 feet away.
STAND BY
-
Pressing this button will blackout the fixture.
FULL ON
-
Hold this button down to fully light up the unit. When you
let the button go, the unit will return to its previous state.
FADE/GOBO
-
Press this button to enter Gobo mode. Use the 1-9
buttons to select your desired gobo. Adjust the output intensity using
the “” and “DIMMER -” buttons.
“” and “DIMMER -” -
Use these buttons to adjust the out-
put intensity and to adjust the strobe speed.
STROBE
-
This button will activate the strobe effect. You can control
the flash rate by pressing the “” and “DIMMER -” buttons.
If you press and hold this button the unit will begin to strobe.
COLOR
-
Press this button to enter Dimmer mode. Use the 1-9 but-
tons to select your desired color. Adjust the output intensity using the
“” and “DIMMER -” buttons.
1-9
-
When in either Gobo mode or Color mode, these buttons will
allow you to select either a gobo or color.
SOUND ON & OFF -
These buttons activate and deactivate the
sound active mode.
SHOW -
This activates the show mode. Use the “DIMMER +” and
“DIMMER -” buttons to scroll through the 4 shows.
Inno Pocket Spot
Remote Operation
Inno Pocket Spot
Master-Slave Set Up
Master-Slave Operation
This function will allow you to link up to 16
units together and operate without a controller. The units will be sound
activated. In Master-Slave operation one unit will act as the controlling
unit and the others will react to the controlling units programs. Any unit
can act as a Master or as a Slave.
1. Using approved DMX data cables, daisy chain your units togeth-
er via the XLR connector on the rear of the units. Remember the
Male XLR connector is the input and the Female XLR connector
is the output. The first unit in the chain (master) will use the female
XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a termina-
tor at the last fixture.
2. On the Master unit press the MENU button until “
SLND
” is dis-
played, and press ENTER. Use the UP and DOWN buttons to
scroll to the “MAST” setting and press ENTER.
3. After setting the Master unit to the master setting find your
desired operating mode.
4. On the slave units press the MENU button until “
SLND
” is dis-
played, and press ENTER. Choose either “
SL 1
” or “
SL 2
” and
press ENTER. See page 10 for more info.
5. The slave units will now follow the Master unit.
