• Be sure to save the packing carton in the unlikely event the unit
may have to be returned for service
• Do not spill water or other liquids into or on to your fogger. Be
sure that all the fog fluid is kept inside the fluid reservoir
• Be sure that the local power outlet match that or the required
voltage for your fog machine
• Do not remove the top cover under any conditions. There are no
user serviceable parts inside
• Disconnect the unit’s main power when left unused for long peri-
ods of time
• Never connect this unit to a dimmer pack
• Do not attempt to operate this unit, if it becomes damaged in anyway
• Never operate this unit when it’s cover is removed
• To reduce the risk of electrical shock or fire, do not expose this
unit rain or moisture
• Do not attempt to operate this unit if the power cord has been fray-
ed or broken. Do not attempt to remove or break off the ground
prong from the electrical cord. This prong is used to reduce the
risk of electrical shock and fire in case of an internal short
• Disconnect from main power before making any type of connection
• Never block the ventilation holes. Always be sure to mount this
unit in an area that will allow proper ventilation. Allow about 6”
(15cm) between this device and a wall
• This unit is intended for indoor use only, use of this product out-
doors voids all warranties
• Always mount this unit in a safe and stable matter
• Please route your power cord out of the way of foot traffic. Power
cords should be routed so they are not likely to be walked on,
pinched by items placed upon or against them
• Cleaning -The fixture should be cleaned only as recommended by
the manufacturer. See page 7 for cleaning details
• The unit should only be serviced by qualified service personnel
when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the unit.
C. The unit has been exposed to rain or water.
D. The appliance does not appear to operate normally or
exhibits a marked change in performance.
Fog Storm™ Series
Safety Precautions
Fog Storm™ Series
Description
©
American DJ Supply
®
- Fog Storm™ Series Instruction Manual Page 3
The new Fog Storm™ Series fog machines included a revolutionary
new heating element that has been specially designed to prevent
excessive particle build up that can cause premature fogger failure.
Each of the fog machines in this series include a wide-angle spray
nozzle and long-life pump that was specially designed for high per-
formance fogger output. Each of the fog machines also includes a 25
foot (eight meters) remote control, that may be removed for periods
on non-use. An optional wireless remote control is also available from
American DJ
®
for each of the fog machines and increases the func-
tionality of the fogger greatly.
©
American DJ Supply
®
- Fog Storm™ Series Instruction Manual Page 4
Fog Storm™ Series
Set-Up
1. Open the shipping carton and carefully remove the unit from the
shipping carton.
2. Be sure to remove all the packing material especially around the
nozzle.
3. Set the fog machine on a flat dry surface. Locate the included
bracket from the package and install it using the supplied hard-
ware to the side casing. Note: The bracket is an optional accesso-
ry and may not be used if desired, however if you intend to sus-
pend the unit from truss the bracket must be used.
4. Remove the fluid reservoir and fill it with American DJ
®
branded
fog juice only and replace the reservoir.
5. Place the feeder tube with the filter deep in side the reservoir and
tighten the cap.
6. Firmly attache the remote control unit to the rear remote control
socket on the unit.
7. Plug the unit in to a matching power supply. Wait approximately
five minitues for the fogger to reach normal operating temperature.
8. Follow the operating instructions on the next page for proper
operation.
