Dotz TPar System System Menu
ENTER.
2. “FQN:XX” will now be displayed, “XX” representing the Fre-
quency Rate (Auto Run speed).
3. Press ENTER and the number will begin to flash, use the UP
and DOWN buttons to adjust the speed, 01 being the slowest
and 99 being the fastest. Press ENTER to confirm.
Built-In Programs
- See the chart on page 7 to find
your desired program. Built-In Programs will not be dis-
played, one of the programs listed on page 7 will.
1. Press the MENU button until one of the Programs on page
7 is displayed. The displayed program depends on the last pro-
gram you had set the unit to.
2. Press ENTER to move through the various adjustments of each
program, and use the UP and DOWN button to make adjust-
ments.
Dim Curve
- This setting will let you select your desired
dimming curve.
1. Press the MENU button until “Dim Curve” is displayed, press
ENTER.
2. 1 of 5 dimming curve settings will be displayed: Standard,
Stage, TV, Architectural, or Theatre. Use the UP and DOWM but-
tons to select your desired dimming curve and press ENTER to
confirm.
Pixel Flip
- In this mode you adjust the unit so that the
LEDs in DMX mode will illuminate at your desired starting
point. The unit can start at either the left or the right.
1. Press the MENU button until “Pixel Flip” is displayed, press
ENTER.
ADJ Products, LLC - www.adj.com - Dotz TPar System User Manual Page 9
Dotz TPar System System Menu
The LCD backlight will shut off after 30 seconds, to relight
the background, press the MODE button for 5 seconds.
DMX Mode
-
Set the DMX Address and DMX Channel
Mode -
1. Press the MENU button until “DMX Mode” and underneath
“ADDR: XXX” and “CH:XX” is displayed, press ENTER.
2. “XXX” will now begin to flash, use the UP and DOWN buttons
to find your desired DMX address, then press ENTER.
3. “XX” will now begin to flash, use the UP and DOWN buttons to
find your desired DMX Channel mode, then press ENTER.
Slave Mode
- This will let you set your unit as a slave in
a master/slave configuration.
1. Press the MENU button until “Slave Mode” is displayed. Your
unit will now follow the Master.
Sound Mode
- In this mode the unit will run in sound
active mode.
1. Press the MENU button until “Sound Mode” is displayed.
2. Press ENTER to adjust your sound sensitivity. When you press
ENTER the number next to “Sens” will begin to flash, use the
UP and DOWN buttons to adjust the sound sensitivity. Once you
found your desired sensitivity press ENTER to confirm.
3. When you press ENTER the number next to “FQN” will not
begin to flash, use the UP and DOWN buttons to adjust the fre-
quency rate. Press ENTER to confirm your setting.
Auto Run
-
1. Press the MENU button until “Auto Run” is displayed, press
ADJ Products, LLC - www.adj.com - Dotz TPar System User Manual Page 8
