4
and between the two vehicle walls.
Step 5
Align the three holes of the gasket (3) with the corresponding insulator (4) holes, and
place the two in position, on the outside on the vehicle wall.
Step 6
With the forefinger, position the "C" shaped plate with the open end pointing
downwards or towards direction of antenna lead-in cable. Fasten plate loosely with
two of the supplied hex screws (1A, 1B). Remove the "fish" wire and tighten the two
screws.
Step 7
Complete the installation by performing
Steps 5
through
13
of the installation
procedure on single wall construction vehicle.
Vehicle
Walls
11
16
5
3
9
12
18
4
8
1A
6
7
10
17
15
14
13
2
1B 1C
Installing Antenna
FAD-1400
Assemble the antenna whip by screwing together the three (or optionally four)
antenna sections.
Place lockwasher (20) on the antenna bushing (19), and then screw securely the
antenna whip into the antenna receptacle of the mounting spring (11).
TAA-1000
Place lockwasher (20) on the antenna adapter (21), and then screw securely
antenna adapter into the antenna receptacle of the mounting spring (11). Insert
the TAA-1000 end into the antenna adapter (21) and tighten the 3 set screws
(22) with Allen wrench.
Vertical
Adjustme
nt
If necessary, loosen Allen head screw (8) with Allen wrench, and readjust the
upper hemisphere (9) for vertical antenna position. Tighten the Allen head screw
(8).
