American Changer AC107, Инструкция по установке, эксплуатации и обслуживанию, Страница: 17 / 35

15
Credit
Card Credit Card System error conditions. If the credit card
processing fails, the display shows a “Cash only” message.
No Comm The Flex-2 main logic board is unable to communicate with
the credit card system.
No Reader Reader is not connected or defective. (Only if using DataCap
IPTranLT with Magtek Reader)
Coin
Acceptor Coin Acceptor Error Conditions
Credit Sns.
Credit sensor blockage or failure
Piezo Sns.
Piezo sensor blockage or failure
Exit Sns. Exit sensor blockage or failure
Reject Sns.
Reject sensor blockage or failure
Return
Mech
Unit failure. Needs to be replaced.
Thermistor Thermistor failure
No Comm The Flex-2 main logic board is unable to communicate with
the coin acceptor.
3.4 – Programming Menu for the AC107 and AC110
To enter the programming menu, begin by pressing the “Select Switch” on the Flex-2 main logic board.
Pressing the select switch will bring the display to show “Enter Access Code.”
Use the Flex Programmer Board to enter the access code. The default code from the factory is “1234”
To exit the programming menu or the “Enter Access Code” screens press the “Select Switch”
Use the Flex Programmer Board to navigate the menus. Press the “Cancel” button and enter a menu
number to be brought immediately to that menu or press the
Back/Next button to step through the
menus.
All the menus work the same:
No/Yes : Selects status
Back/Next : Selects the item
Exit : Exits the setup menu