4211-197 08-24-12
6 x 9 Waterproof Speakers
Installation Instructions
4. Remove the grill then the foam sheet from the speaker frame.
5. Swing the plastic tabs (clamps on back of the speaker) to their most counterclockwise position.
Note
:
If mounting the speaker in a wet location, make sure the mounting gasket is in place or
add a bead of silicone to seal the speaker to the mounting surface before installing the
speaker in its mounting cut-out.
6. Insert the speaker into the mounting cutout then tighten the four stainless steel screws located
in the front panel of the speaker. Tighten until the speaker is
fi
rmly secured in place.
Note: If the mounting surface is thicker than 3/4” (19mm), the plastic clamps may
be trimmed back to accommodate a wall thickness of up to one inch.
7. Carefully place the foam sheet on the front of the speaker and remount the grill.
For additional assistance contact Amerec Technical Support at 1-800-363-0251.
P.O. Box 2258 Woodinville, WA 98072
800-363-0251 Fax: 425-951-1130
email: address: [email protected]
Front
Rear
Mounting Tab Screws
Mounting Tab
