AMD ATI FireMV 2260, Руководство пользователя

Страница: 25 / 87

Problem Possible Solution
The screen
image is
off-center
or there are
odd colors.
Try adjusting the brightness, sharpness, contrast, and color
balance controls of your monitor.
Try adjusting the centering and positioning controls of your
monitor to position the picture on the screen.
Set the monitor's RGB inputs (and sync switches, if this option is
available) to 75 Ohms, with the sync set to external.
DFP monitor users: Make sure that the DVI plug of your monitor
data cable is digital-only (DVI-D) - but not integrated analog/digital
(DVI-I). Refer to your monitor's documentation and contact your
supplier or the manufacturer of the DFP monitor for information
on how to obtain a suitable data cable plug.
The
operating
system
warns that
the
graphics
card isn't
properly
configures.
Make sure that the display resolution and refresh rate settings you
have selected are supported by the monitor you have connected.
Check the driver installation and make sure that all software is
correctly loaded corresponding to your operating system and
applications.
Reinstall the drivers for your graphics card.
Stereo
glasses are
not
working
properly.
Make sure your stereo glasses are connected to the graphics card
when you start your computer.
Make sure you select a refresh rate of 120 Hz.
Enable the
Quad Buffer Stereo option.
There are
bus
address or
interrupt
conflicts.
Make sure that the I/O and memory addresses reserved for the
graphics board are not used by other hardware devices. The
integrated on-board VGA controller of your ATI FireMV card uses
the following addresses (hex):
•
I/O Address: Standard VGA I/O: 3B0-3DF
•
Memory Addresses: Video RAM: A000-BFFF, Video ROM:
C000-C7FF
You cannot change the addresses of your ATI FireMV card. In case
of an address conflict, try to modify the I/O address of the add-on
card that causes the conflict.
To support the special graphics processor on the ATI FireMV card,
the system BIOS should automatically assign a system interrupt to
the slot where the card is installed. However, there may be
problems if your graphics card does not receive an interrupt or a
system interrupt is used for more than one device. In case of
problems, check the system configuration utility of your operating
system for the interrupt assignments.
19
©
2008 Advanced Micro Devices, Inc. ATI™ FireMV™ 2260