Amcon Auto Chart Projector
13
5.2 Operation of the remote controller
1. Turn the projector’s power switch on. The chart will automatically reset to the
start position and the lamp will light.
2. When using the remote controller, point the remote signal emitter in the direction
of the remote sensor on the front of the projector.
3. The switch functions are as follows
a)
Chart
Switches
Projects
the indicated chart on the switch.
b) Light Switch
Turns the lamp off and on.
c) Reset Switch
Returns to chart 1 of the program.
d) Program Forward Switch
Fowards the program automatically.
e) Program Back Switch
Reverses the program automatically.
f) Highlight Selector
Isolates chart characters. (Horizontal Line of
Characters, Vertical Line of Characters, Single
Character).
g) Highlight Transfer Selectors Moves the isolation of the characters in the
direction indicated.
When the highlighted area of a chart being projected advances to the maximum
or minimum on that chart, the next or previous chart in the sequence will
automatically appear. Charts can be switched within the same type.
h) R&G Switch
Applies the R&G filters to the designated charts.
i) Program Switch
Refer to the Program Procedure, section 5.3, for
using this function.
Note
: The projector will automatically turn off if not in use for 5 minutes.
