AMCI RBE2-8, Руководство пользователя

Страница: 22 / 55

I
NSTALLING THE
RBE2-8
RBE2-8 User Manual
ADVANCED MICRO CONTROLS INC.
22
1.3b Panel Mounting
Follow these instructions when mounting an RBE2-8 on a panel.
1.3b.1 Attach the Panel Mount Brackets
Figure T1.3 shows how to remove the DIN rail mounts so the RBE2-8 can be mounted to a panel.
Figure T1.3 Panel Mount Bracket Conversion
1.3b.2 Dimensions
Figure T1.4 shows the dimensions of the RBE2-8 Networked Relay Board when panel mounting.
Figure T1.4 RBE2-8 Panel Mount Outline
When panel mounted, the RBE2-8 is typically grounded through its mounting hardware. If
needed, a wire from the grounding connection on the power connector to the system ground bus
can be installed. Refer to 1.4,
Power Wiring on page 23 for additional information.




1) Remove the two screws that hold the bracket in place.
2) Remove the bracket.
3) Slide the plastic DIN adapter off of the channel to remove it.
4) Reverse the bracket and reattach it to the relay board with
the two screws.
REPEAT THESE STEPS TO CONVERT THE OTHER SIDE.
MODULE
STATUS
OUTPUT MODE:
GND +24V

ON
COMM.
ERROR
MODE
GRN / NORMAL
RED / ALL OFF
OUTPUT
MODE
TOGGLE
RESET
MODULE
NETWORK
STATUS
2.44"
[62.0]
0.21"
[5.3]
4.00"
[101.6] 0.75" per output [19.1]
10.00"
[254.0]
10.00"
[254.0]
10.40"
[264.2]
10.80"
[274.3]
11.25"
[285.8]
2.
5
0
"
[63.5
]
2.
7
5
"
m
a
x
.
[69.9]
0.65"
[16.5]
2.
0
7
"
[52.6]
2.
9
4
"
[74
.7]
3.
80
"
[96.5]