AMC XTa, Инструкция по установке и эксплуатации

Страница: 9 / 16

6. INFO
For DAB/DAB+ Band
The "INFO" button selects Main Service
Name, Signal Strength (antenna symbol
and signal strength by number of
segments display on display), Time & Date
(Time & Date info on display), Program
Type, Signal Type (Stereo/Mono, bit rate
for DAB/DAB+ etc), TEXT, Service code
and Frequency.
For FM+ Band
The button has no function during FM+
Band.
7. DAB/DAB+/FM+ DISPLAY
8. IR RECEIVER
FOR AM/FM MODULE (RIGHT SECTION
& DISPLAY)
9. AM/FM DISPLAY
10. & 11. TUNING DOWN & TUNING
UP
12. MONO
13. MODE
14. AM FM
15. Zone
This is the Display of DAB/DAB+/FM+
status and data.
The IR Receiver is for both DAB/DAB+/
FM+ and AM/FM Modules.
This is the Display of AM/FM status and
data.
Tuning up or down the AM and FM bands
is accomplished by pressing either of the
two TUNING buttons. Press the
Up
Button to tune toward higher frequencies
or the
Down Button to tune toward lower
f r e q u e n c i e s . W h e n t h e A M / F M i s i n
MANUAL mode, the tuning frequency will
change in small steps. When the AM/FM is
in AUTO mode, the frequency will continue
t o a d v a n c e r a p i d l y t i l l t h e b u t t o n i s
released. Observe the Tuning indicators
while fine tuning to obtain maximum signal
strength. On FM, fine tune till the center
tune indicator is illuminated.
When a stereo FM signal is detected, the
tuner automatically switches into stereo
mode and displays the "S". However, very
w e a k F M s t a t i o n s i g n a l s m a y b e
excessively noisy. Pressing the MONO
button disables the stereo FM circuits in
the tuner resulting in significant reduction
of noise. The "ML" is displayed when
e n f o r c e d L o c k e d m o n o o p e r a t i o n i s
engaged. Remember to disengage the
MONO button when tuning to normal
stronger stations because as long as the
MONO button is engaged, broadcasts
cannot be received in stereo.
The "MODE" button selects AUTO ( [A] on
display ), Manual ( [M] on display) &
Preset ( [P] on display( Preset number Pxx
will display on right hand side of [P] on the
Display).
This button switches between the two
tuning bands: FM or AM. The digital tuning
display shows the tuned frequency in MHz
(for FM) or KHz (for AM). The tuning circuit
m a i n t a i n s a " l a s t s t a t i o n s e l e c t e d "
memory, returning to the previously
selected station when switching between
bands.
The Zone number can only be controlled
from RS232 and Zone # set will be display
on top lefthand side of display. (Zx)
7