In case you wish to replace the front cover, after having removed the rear part of the keyboard, remove
its electronic part by acting on the 2 fastening tabs (see drawing).
Remove the old cover and assemble the new one and the electronic circuit, following the steps indicated
in the drawings below.
Step 1
= assembly of new cover
Step 2
= assembly of electronic board
Caution: the “glass slide in plastic” must be positioned all the
way to its limit stop on the electronic board
Step 3
= locking of the electronic board
the electronic board must stay locked tight by the specific
fastening tabs (see drawing).
Keyboard adjustments.
To access the menu of the parameter settings of the Keyboard, simultaneously touch the “X” and “V”
enter symbols.
Use the UP and DOWN arrow keys to scroll through the:
-
Keyboard ID
(to set the hardware address of the Keyboard)
With the Right and Left arrow
keys, set a value between 01 and 16 (default: 1)
-
Transponder ID
(to set the hardware address of the Transponder)
With the Right and Left
arrow keys, set a value between 01 and 16 (default: 1)
-
Display Brightness
(to set the Brightness of the Display)
With the Right and Left arrow keys,
adjust the parameter until you have the desired brightness. Value between 01 and 16 (default: 16).
-
Display Contrast
(to set the Contrast of the Display)
With the Right and Left arrow keys, adjust
the parameter until you have the desired contrast. Value between 01 and 15 (default: 15)
Fase
1
Fase
2
Fase
3
Linguette
aggancio
