AMC CVT3030MKII, Инструкция по установке и эксплуатации, Страница: 6 / 12

5
If your tape machine processing DIN
outputs, then DIN/phono leads, or a
DIN/phono adaptor can be used. If you
experience level matching problems
when using DIN connectors, please
consult your tape machine manufacturer.
These RCA jacks provide the preamplifier
outputs which are adjusted by the volume
control. Normally it is connected to the
main-in input of an external power
amplifier.
The loudspeaker output terminals will
accept
4mm(banana)plugs, spade
connectors, pin connectors or bare wires.
The amplifier has speaker outputs that
will match 4 - 8 ohm speakers. Confirm
the impedance of your speakers then
connect as follows:
For 8 ohm speakers, connect the
negative (black) speaker wire to the
"common" negative binding post.
Then
connect the positive (red) cable to the 8
ohm red binding post.
For 4 ohm speakers, the negative (black)
connections are the same as the 8 ohm,
but the positive or red connection must be
to the 4 ohm binding post.
Your AMC amplifier is capable of
generating high peak currents, so all
connections must be checked to avoid
inadvertent short circuits, and to ensure a
good clean contact.
PRE OUT
LOUDSPEAKER CONNECTIONS
UNDER NO CIRCUMSTANCES SHOULD
THE OUTPUTS BE SHORTED TOGETHER.