AMC 27100MKIIse, Инструкция по установке и эксплуатации, Страница: 5 / 8

4
REAR PANEL CONNECTIONS
1. MAINS INLET
Connect the AC line cord in to the mains inlet
and plug the AC cord plug into a nearby wall
outlet that provides the correct AC power line
voltage.
2. INPUT LEVEL CONTROLS
Each channel of the 2
7
100MKII
se
has its
own, independent level control. Before
turning on the 2
7
100MKII
se
for the first
time, make sure that all level controls are
set to their fully clockwise position. These
controls can be used for various functions.
For example, they can be used to
match the levels of loudspeakers in a
multi-room installation, or to lower the
sensitivity of the power amplifier, so that the
volume control on pre-amplifier is at a more
convenient and usable position. They can
also be used to optimise the balance in a
stereo system.
3. LINE OUTPUTS
Each input has an accompanying line output
which will pass the signal onto another
amplifier input or other line-level device.
4. LINE INPUTS
There are five RCA phono connectors on the
back panel that connect to the inputs of each
of the power amplifiers.
5. LOUDSPEAKER TERMINALS
The 2
7
100MKII
se
is equipped with binding
post type speaker terminals that are
desiged to handle the extremely high peak
currents that this amplifier is capable
of giving. Connections from these
terminals to the loudspeakers should be
made with heavy-duty wire. Standard wire
of 16 gauge or thicker is recommended
especially if low impedance loudspeakers
are used.
FRONT PANEL CONTROLS
1. POWER SWITCH
The press button switch marked power can
be used to switch the 2
7
100MKII
se
on or
off. When the 2
7
100MKII
se
is switched
on, the small indicator above the power
switch will be lit.
UNDER NO CIRCUMSTANCES SHOULD
THE CASE OF THE AMPLIFIER BE
OPENED BY ANYONE OTHER THAN A
QUALIFIED ENGINEER, AS DANGEROUS
VOLTAGES ARE PRESENT INSIDE. ANY
U N A U T H O R I Z E D R E P A I R M A Y
INVALIDATE YOUR WARRANTY.